Zanussi ZDM11301WA Manual De Instrucciones página 7

Using the detergent
1
A
3
Fill the detergent dis-
penser (A) with de-
tergent.
A
5
Combi detergent tablets
These tablets contain detergent, rinse aid and
other added agents. Be sure that these tablets
are applicable to the water hardness in your
area. Refer to the instructions on the packag-
ing of the products.
When you use tablets, that contain salt and
rinse aid, do not fill the salt container and the
rinse aid dispenser.
1. Adjust the water softener to the lowest lev-
el.
www.zanussi.com
2
B
4
If you use a washing
programme with pre-
wash phase, put
more detergent in the
prewash detergent
compartment (B).
6
2. Set the rinse aid dispenser to the lowest
position.
If you stop to use the combi detergent
tablets, before you start to use
separately detergent, rinse aid and
dishwasher salt, do these steps:
1. Turn the programme knob until the pro-
gramme marker is aligned with the shortest
programme with a rinsing phase.
2. Set the water softener to the highest level.
3. Make sure that the salt container and the
rinse aid dispenser are full.
4. Start the set programme, without detergent
and without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse aid.
Setting and starting a programme
Setting mode
The appliance must be in setting mode to
start a programme.
• Turn the programme knob until the pro-
gramme marker is aligned with a programme
on the control panel. If the on/off indicator
comes on and the phase indicators for the
programme start to flash, the appliance is in
setting mode.
• Turn the programme knob until the pro-
gramme marker is aligned with a programme
on the control panel. If the on/off indicator
and the start indicator come on and a phase
indicator is on with fixed light, the appliance
is not in setting mode.
To put the appliance in setting mode, press
and hold the start button until the start indica-
tor goes off and the phase indicators for the
programme start to flash.
Starting a programme without delay start
1. Open the water tap.
2. Close the appliance door.
3. Turn the programme knob until the pro-
gramme marker is aligned with the pro-
gramme you want to set.
• The on/off indicator comes on.
7