CEMB SM1100 Manual De Uso página 35

SPECIAL WHEELS
Wheels with alloy rims: some wheels with alloy rims
have a minimum A rim channel or do not have any
channel - Fig. 13A. These rims are not approved by
DOT standards (Department of Transportation). The
DOT initials certify that tyres comply with the safety
standards adopted by the United States and Canada
(these wheels cannot be sold in these markets).
High performance wheels (asymmetric curvature)
- Fig. 13B some European wheels have rims with very
pronounced curvature C, except in the area of the
valve hole A where the curvature is less pronounced
B. On these wheels the bead must first be broken in
correspondence of the valve hole, on both the top
and bottom sides.
Wheels with pressure sensor - Fig.13C. To work
correctly on these wheels and avoid damaging the
sensor (which can be incorporated in the valve, se-
cured to the belt, glued inside the tyre, etc.) suitable
mounting/demounting procedures must be observed
(refer to "Approved mounting/demounting procedure
for runflat and UHP tyres").
The TPMS device (optional accessory) can be used to check the proper opera-
tion of pressure sensor.
Remove the old weights from the rim before starting work operations.
User's manual
WARNING
WARNING
A
A
B
A
C
A
B
13a
EN
13b
C
13c
B
C
13d
35