Primer LP-08 Manual De Instrucciones página 27

•
Units of measurement: The unit of measurement in which the temperature (ºC (default setting) or
ºF), the weight (Kg (default setting) or lb) and the size (mm (default setting) or in) can be selected.
•
Thermal stop: General configuration of the thermal stop. If this is disabled, the thermal stop does
not take place even if this parameter is active in the currently running cycle. If, however, it is enabled, the
configuration of each cycle is respected and the consequent action is taken. By default it is active In
machines without heating, (HW) is always deactivated.
•
Water saving by weight: The required water saving for the weight can be configured. Three
different weight options and three levels of saving can be selected.
Depending on the load, there will be a reduction in the water level and detergent dose.
•
Weight option off.
•
Automatic weight option. This is available depending on the configuration of existing kits.
•
Manual weight option. Enter the weight of the clothing manually by pressing the weight icon
on the main screen. (See section 2.2, point 3).
•
Smart weight option. This option estimates the load weight at the start of each programme.
The message "LOAD DETECTION" is displayed while it is running. This option may last several
minutes. The time required for this is not included in the programme duration.
23