Start The Machine (When Connected To Open Containers (Suction Mode)); Pressure Regulation On The 4-In-1 Spray Lance; Operation With Detergents - Berner BHPC 150-1 4-in-1 Lance Manual De Instrucciones

BHPC 150-1 4-in-1 Lance
DE
5.5 Start the machine (when
connected to open con-
EN
tainers (suction mode))
FR
IT
ES
NL
DA
NO
5.6 Pressure regulation on
SV
the 4-in-1 spray lance
FI
PT
5.7 Operation with
detergents
36
The washer can take in water
from a rain water tank as an
example. The hose for the water
supply must not be too long,
approx. 5 m.
Make sure that the water tank is
not placed on a lower level than
the machine.
Use an external fi lter if the wa-
ter contains impurities.
1. Make sure that the water
hose is fi lled completely with
water before connecting to
the machine. Place the entire
Application of detergents is
NOT possible if an extension
hose is applied.
hose in a tank or bucket. To
avoid water spillage, crimp
the water inlet hose down in
the water and then connect
the hose to the machine with
the quick coupling and fi nally
uncrimp the water inlet hose.
2. Dismount spray handle,
lance and nozzle.
3. Turn the start/stop switch to
position "I" and let the water
run, until the air has escaped
from the water hose and the
pump.
4. Mount spray handle, lance
and nozzle again.
The pressure can be regulated
on the 2-in-1 spray lance.
Low Pressure / detergent
Tornado / high pressure
Wide angle / high pressure
Turbohammer / high pressure
1. Fill the container with a de-
tergent.
2. Mount the 4-in-1 spray lance
and adjust the nozzle to pos
Low Pressure/Detergent (see
section 5.6).
3. Adjust the dosing regulator
(10) to the re quired vol ume
of detergent (0-5%).
4. Apply the detergent from
below and up wards.
5. Let the detergent act for the
time stated on the packing of
the detergent and fl ush with
pure water.
Original Instructions