Maintenance And Cleaning - VOLTOTHERM WW 1200 Manual De Instrucciones

Anleitung WW 1200 - WW 2000 SPK7:Anl WH 2000 PTC SPK1
6.3 Thermostat control (Fig. 1 / Item 3):
Switch on the desired heat output with the heat
output switch. Turn the control to "HI" until the
required room temperature is reached. The
temperature indicator LED comes on. Then turn the
control back until the temperature indicator LED goes
out. The thermostat control will switch the radiator on
and off automatically to maintain the room
temperature at an almost constant level. However,
this presupposes that the radiator has sufficient
output to cover the heating requirements for the
room.
Note: "LO" setting = antifreeze setting
6.4 Overheat cut-out
In case of excessive heating, the appliance shuts
down automatically. If this occurs, turn off the
appliance, disconnect the mains plug and wait a few
minutes for the appliance to cool. After eliminating
the cause (e.g. a covered air grille), the appliance
can be switched on again.

7. Maintenance and cleaning

Before carrying out any cleaning and maintenance
work the appliance must be turned off,
disconnected from the power supply and cooled
down.
Maintenance and repair work may only be carried
out by an electrical servicing contractor.
Check the mains lead at regular intervals for signs
of defects or damage. A damaged mains lead may
only be replaced by an electrician in compliance
with the relevant regulations.
Use a damp cloth to clean the casing.
Remove dust pollution with a vacuum cleaner.
8. Storage
The radiator has to be stored in a dry place, covered
if possible.
25.06.2007 15:42 Uhr Seite 9
GB
9