Publicidad
Idiomas disponibles
Idiomas disponibles
Do not clean the appliance when in operation and do not
immerse it in water.
Do not manipulate the appliance with wet hands.
Do not wrap the power cable round the appliance while it
is in operation.
If the cable is damaged it must be replaced; do not do this
yourself – take the appliance
to an authorised repair centre, as this operation must be
carried out by specialised personnel to avoid hazards or
damage.
Do not use the appliance as a clothes or towel drier.
This heater is not equipped with a device of room
temperature control. Do not use this heater in small rooms
that are occupied by people who can not leave the room
by themselves, unless ongoing monitoring is assured.
3.
INSTALLATION/ WALL FITTING
Carefully read the Safety warnings before starting to install the appliance.
Make sure that your power supply corresponds to the details on the specifi cations
plate: 230 V ~ 50Hz.
The appliance must be fitted to the wall, respecting the minimum distances as shown in
Fig. 2.
Installing with the moveable support
.- Using the moving support as a template, mark the 4 holes in the wall. Use a spirit
level to ensure the support is completely horizontal.
.- Then drill the 4 holes in the wall using an 8 mm diameter drill. Insert the four bolts with
metal wall plugs.
.- Join by 6 metric screws, the wall heater with the heater body.
.- The appliance fixed carefully, so that it is oriented at 90º (Figure3), if you want to
change the orientation to 75º (Figure 3), change the position of M3 screw located in the
kneecap with a screwdriver.
.- Using the 4 nuts, secure the assembly to the wall. Use the key provided.
13
Publicidad
