Hayward DE2420EURO Manual Del Usuario página 11

⚠
WARNING
Failure to follow instructions can cause injury.
⚠
WARNING
kept by the owner in a safe place.
⚠
WARNING
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for their
safety.
⚠
WARNING
Closely supervise children at all times.
⚠
WARNING
start up, normal operation, and possibly after pump shut off. Pressure in system can cause explosive
component separation of the upper filter body if safety and operation instructions are not followed.
Severe personal injury or death can result.
⚠
WARNING
TO AVOID COMPONENT SEPARATION
• Follow all safety and operation instructions.
• Do not operate water circulation system if a system component is assembled improperly,
damaged, missing, or not a genuine Hayward component.
• Before performing maintenance on the water circulation system, verify all system and pump
controls are in OFF position and filter manual air relief valve is in the OPEN position.
• Use ONLY Hayward clamp system components: DEX2421JKIT clamp assembly, DEX2421J2 nut/
bolt assembly, and a DEX2422Z2 metal reinforced seal. Non-Hayward components may fail in use
and cause explosive separation.
• Never rely on hand tightening the clamp nut to the clamp bolt. Using a ¾ inch socket on a torque
wrench, torque clamp nut and clamp bolt to 17 Nm (150 inch-lbs).
• Before starting system pump, insure filter manual air relief valve body is in LOCK position in filter
upper body.
• Before starting the system pump, verify that all system valves are set in a position to allow water
from the filter to return back to the pool.
• Before starting the system pump, the manual air relief valve must be in the OPEN position.
• When starting pump, do not stand over or near filter.
• If water leakage appears in the area of the filter tank clamp, immediately turn off all system
circulation pumps and electrical power. Do not return to the filter until all water flow has stopped.
Reassemble the clamp system per the instructions in this owner's manual to stop the leak.
• Return to filter to close manual air relief valve only when a steady stream of water (Not air or air
and water mix) is discharged from the manual air relief valve.
• Do not change filter control valve position while system pump is running.
⚠
WARNING
cause explosive separation of the components. Component separation can result in severe personal
injury or death.
Page 2 of 8
-
Read and follow all instructions in this owner's manual and on the equipment.
– This document should be given to the owner of the swimming pool and must be
– This appliance is not intended for use by persons (including children) with reduced
– To reduce risk of injury, do not permit children to use or climb on this product.
– Pool and spa water circulation systems operate under hazardous pressure during
– This product should be installed and serviced only by a qualified pool professional.
– Pressure testing of the pump and filter system in excess of the 3,5 Bar (50 PSI) can
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Pro-Grid Rev. A