Firmware Updating - FONESTAR AIP-1020 Manual De Usuario

EN
Once all the parameters have been configured, select the Generate option and add the file to the root of a
USB storage device.
Then, insert the USB storage device in the corresponding port on the rear panel of the device, with the device
switched off. Now, switch the device on.
If the configuration has been completed successfully, 30 seconds after starting, all the buttons will emit a blue
flashing light, repeating 3 times.

FIRMWARE UPDATING

There are two ways of updating the AIP-1020 microphone firmware: via an update file or via the AIP-Go
application. With both options, download the update file from the fonestar.com website. In order to do so,
go to the product Software tab (AIP-1020) and download the update file.
UPDATE FILE
Once the update file has been downloaded, add it to the root of the USB storage device.
Insert the storage device in the USB port on the rear panel of the device, with the device switched off. Then,
switch the device on while pressing and holding any button on the front panel.
Press and hold the button while the device is finding the update file in the USB storage device. After 30
seconds, all the buttons on the AIP-1020 will emit a flashing light among: off, red and blue, repeating 5 times.
If the updating has been performed successfully, all the buttons will emit a blue light. At this moment, stop
pressing the button and after 30 seconds the device will be ready for use.
10.- Allows connection parameter change to be
activated/deactivated.
11.- Allows the multicast group that the device will join
to be selected. Use the default option or configure
the group by entering the values.
12.- Allows modification of the port for communication
between the microphone and the rest of the
devices.
13.- Allows the lifetime of the data in the network to be
defined.
- 4 -