Fitting Instructions - S&P ARTIC-255N GR Instrucciones De Uso

FITTING INSTRUCTIONS

1. Pass the power cable through the fan base (Fig. 1)
2. Slot the foot of the motor support into the circular fan base and fix with the rear clips. (Fig.
1)
3. Place the power cable in the groove located in the back part of the base, to ensure that the
fan is stable. (Fig. 1)
4. Loosen the fixing nut of the rear grille, which is screwed on the motor head.
5. Place the rear protection grille and screw it with the fixing clamp of the rear grille. (Fig. 2)
6. ARTIC 255N model: Introduce completely the propeller on the motor shaft (Fig. 2)
ARTIC 305N / 405N models: Introduce the propeller fully on the motor shaft and fix with
the fixing nut. (Attention to the direction arrow indicated on the fixing nut) (Fig. 2)
7. Check the propeller by turning it manually. Be sure that the propeller turns freely. If neces­
sary repeat steps 1 to 3.
8. Place the front protection grille by introducing the hook on the upper part into the rear grille.
Put the two grilles together and press them until they get well placed on the plastic frame.
9. Close the security clamp on the bottom of the front grille and fix it with the screw.
OPERATION
Once checked that the tension matches with the tension showed on the characteristics plate,
plug the fan and turn the main switch to all the positions.
The ARTIC-255 N model has a three positions switch:
0 = Stop
1 = Low speed
2 = High speed
The ARTIC-305 N and ARTIC-405 N models have a four positions switch:
0 = Stop
1 = Low speed
2 = Medium speed
3 = High speed
OSCILLATION
The fan has a feature which allows the oscillation of the head from side to side of the basis. To
make the fan oscillate, you must press the oscillating switch. To stop the oscillation, just pull
the switch upward (Fig. 3).
SWINGING OF THE HEAD
The ARTIC N fans have a multi-swinging head. To lean it you only have to press over the fan
adjusting it to the desired angle (Fig. 3).
9