Publicidad
Idiomas disponibles
Idiomas disponibles
• Disconnect the terminals of the box connection in the pump, paying attention to its
position.
• Take out the wire, replace it, and proceed in an inverse described way.
Maintenance
Councils for cleaning
VERY IMPORTANT: before turning on the pump after a long period of stagnation, verify
that the axis of the engine is not squeezed tight, moving it with a flat screwdriver, through
the ventilation lid, beside the wound of the engine, until the axis is liberated and turns to
right and left side. It is suitable, likewise, to be sure that the filter is primmed before a take-
off after a continued stop.
The filtration pump is prepared to work without any type of specific maintenance.
Nevertheless, the utilization of the equipment in swimming pools with a high index of dirt,
specially leaves, can obstructe the axis. In such a circumstance proceed as a follows:
• Disconnect the equipment.
• Put the valve in CLOSED position.
• Put the stopper of the skimmer.
• Disconnect the connection of aspiration and the drive of the pump.
• Slacken the screws that hold the lid of the pump body.
• Clean the bun. If it is broken, call the technical service for replacement.
• Mount the pump lid assuring that the O-ring remains centered and tight.
• Mount the aspiration and the drive of the pump.
• Remove the stopper in the skimmer.
Publicidad
