Anleitung BAFS 18
07.04.2003
GB
To ensure that the battery pack provides long ser-
vice, you should take care to recharge the NC bat-
tery pack promptly. You must recharge it if you find
that the performance of the machine has fallen.
Never fully discharge the battery pack. This will
cause it to develop a defect.
5.2 ON/OFF switch (Figure 1)
Infinitely variable speed control of the blade is possi-
ble with the ON/OFF switch. The further you push
the switch, the higher the speed of the cordless
saber saw.
5.3. Changing the saw blade (Fig. 3/4)
Always switch off and unplug the multi-saw before
working on the machine or changing the saw blade.
Unscrew the screw on the ram (8) using the Allen
key (10) included in delivery. Slide the blade bet-
ween the piston rod and the retention clip (9) in the
ram and make sure that the pin on the ram latches
into the hole in the blade. Re-tighten the screw using
the Allen key (8). The teeth of the blade must face
the direction of cutting.
6. Use as a jigsaw (Fig. 5)
Place the multi-saw on the material to be cut as
shown in Fig. 5. Switch on the multi-saw and push it
along against the material to be cut. Adapt your cut-
ting speed to the material.
Wear goggles
Wear ear-muffs
7. Maintenance
Remove the battery before you work on the saw.
Always keep the machine clean.
Do not use any caustic materials to clean the plastic.
8. Technical data
Voltage supply:
8
15:07 Uhr
Seite 8
Stroke rate:
Stroke height:
Cutting depth in wood:
Cutting depth in iron:
Battery charging voltage
Battery charging current
Mains voltage for charger
Sound power level LWA
Sound pressure level LPA
vibration a w
weigth
9. Ordering replacement parts
Please quote the following data when ordering repla-
cement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
Item No.
switch
charger
battery
!
Old and defective batteries do not belong in the refu-
se bin. Think of the environment! Cadmium is toxic.
For correct disposal, return old and defective batte-
ries postage-paid to ISC or take them to your local
old battery depot. Ask at your town hall for details of
the old battery depots in your area.
18 V =
0-2700 min.
22 mm
85 mm
6 mm
18 V =
400 mA
230 V ~ 50 Hz
82,8 dB(A)
95,7 dB(A)
14,4 m/s
2
2,4 kg
Art. No.
45.130.00.01
45.130.00.02
45.130.09
iNTERNATiONALES SERViCE CENTER GmbH