Layout; Items Supplied; Intended Use - EINHELL NEW GENERATION NHL 2000 Manual De Instrucciones Original

Anleitung_NHL_2000_SPK7:_
assistance.
Leaked battery fluid can cause skin irritation and
acid burns.
If you do not intend to use the remote control for a
lengthy period of time, remove the battery from
the battery compartment. Any leakage of battery
fluid might damage the remote control.
Swallowing batteries can lead to loss of life. Store
batteries out of children's reach. If a battery is
swallowed, seek medical help immediately.
Do not place batteries on heaters or expose them
to direct sunshine for long periods; temperatures
in excess of 50 °C may damage the equipment.
2. Layout (Figs. 1-4) and remote
control (Fig. 5)
1. LCD
2. Control panel
3. Air outlet grille
4. Base
5. Recessed handle with drawer for remote control
6. Air inlet grille
7. Power switch
8. Topple cut-out switch
9. Pushbutton for "On/Off function selection"
10. Pushbutton for "Temperature increase"
11. Pushbutton for "Temperature decrease"
12. Infrared receiver for remote control
13. Status indicator LED
14. Pushbutton for "Heating period extension in
minutes"
15. Pushbutton for "Heating period extension in
hours"
16. Pushbutton for "Oscillation"
LCD (Fig. 4)
A – Currently measured room temperature
B – Selected room temperature
C – Oscillation switched on
D – Automatic mode switched on
E – 1000 W heat output selected
F – 2000 W heat output selected
G – Time remaining to run
23.04.2010 12:53 Uhr Seite 13

3. Items supplied

Open the packaging and take out the equipment
with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts.
There is a danger of swallowing or suffocating!
Fan heater
Remote control
Original operating instructions

4. Intended use

The equipment is designed exclusively for use as an
additional heater in dry, closed rooms. It is designed
to be operated only when placed on the floor.
The equipment may only be used for the tasks it is
designed to handle. Any other use is deemed to be a
case of misuse. The user/operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
GB
13