Grex G4.2 Pro Kinetic N Com Seguridad E Instrucciones página 17

7. Side Plates Assembly
To assemble the side plates, first remove the safety cover, the lateral latches and - if
assembled - the visor (see instructions above).
7.1. Push the left visor mechanism deformable fastening "D" upwards until it is out of
its shell seat and then remove the mechanism from the helmet, paying particular
attention not to lose the visor mechanism springs on its back (Fig. 11).
7.2. Insert the teeth of the left side plate in their side seats on the shell, then push the
plate towards the inside of the helmet near the deformable fastening "E" (Fig. 12).
NOTE: The left and right side plates are different from each other and are marked
on their back as R (Right) and L (Left).
7.3. Follow the same steps on the right side of the helmet.
8. Side Plates Disassembly
8.1. Push the left side plate deformable fastening "E" upwards until it is out of its shell
seat, then remove the plate from the helmet (Fig. 12).
8.2. Insert the teeth of the left visor mechanism in their side seats on the shell,
then push towards the inside of the helmet near the deformable fastening "D"
(Fig. 11).
NOTE: The left and right visor mechanisms are different from each other and are
marked on their back as R (Right) and L (Left).
8.3. Follow the same steps on the right side of the helmet.
8.4. If you wish to assemble the visor, see the assembly instructions above.
8.5. Then assemble the lateral latches and the safety covers on both sides of the
helmet as indicated in the assembly instructions above.
WARNING
- When using the helmet in a configuration without visor, always assemble the
lateral latches and the safety covers supplied. Alternatively, it is recommended
to assemble the side plates.
- Do not use the helmet if the visor, the side plates or the lateral latches and their
safety covers have not been assembled properly.
- Should any of the side mechanisms, latches or any of the safety covers fail or be
damaged, please contact a Grex authorized dealer.
VISION PROTECTION SYSTEM (VPS)
The exclusive inner VISION PROTECTION SYSTEM (VPS) is a LEXAN™(*) polycar-
bonate moulded sunscreen with scratch-resistant/fog-resistant treatment. Very sim-
ple and practical to use. Just lower to activate it or lift to remove it from the field of
vision. It is useful in all sorts of situations, both on long journeys out of town and
shorter town trips.
Moreover, the innovative fastening system allows you to assemble and disassemble
the sunscreen without the need for any tools for ordinary maintenance and cleaning
operations.
VPS Operation
The VPS mechanism allows to activate the sunscreen by simply lowering it until it
partially covers the visor field of vision. In this way, the desired light transmittance
reduction is achieved. At any time, without operating the visor, the VPS can be deac-
tivated with a simple movement and easily lifted up to restore the normal conditions
LEXAN is a trademark of SABIC.
(*)
17