Grex G4.2 Pro Kinetic N Com Seguridad E Instrucciones página 20

11.7. Completely remove the liner from the helmet.
11.5. Hold the left front part of the liner and pull it upwards in order to remove the
corresponding liner flap from the support fixed to the polystyrene inner shell
(Fig. 20). Then repeat the same steps for the central front and right flap.
11.6. Remove the chin strap left band from the cheek pad slot (Fig. 21). Repeat the
same operation on the right side of the helmet.
11.7. Completely remove the liner from the helmet.
12. Inner Comfort Padding Assembly
12.1. Insert the chin strap left band in the cheek pad slot (Fig. 21). Repeat the same
operation on the right side of the helmet.
12.2. Insert the left front flap of the liner into its seat on the support fixed to the pol-
ystyrene inner shell and push it downwards until it is completely locked. Follow
the same steps for the central and right flap (Fig. 20).
12.3. Insert the right and left side flaps of the liner, pushing them into the cavities
between the inner polystyrene cheek pads and the outer shell inner side frames
(Fig. 19).
12.4. Insert the rear right, central and left flaps of the liner into the corresponding
seats on the support fixed to the polystyrene inner shell by slightly deforming
the shell edge (Fig. 18). Push the flaps until they are fully hooked onto the sup-
port.
12.5. Hook the roll neck left eyelet to the left frame (Fig. 17), making sure that the
frame central air intake is free. Push the cheek pad padding in line with the snap
fastener on its back by fastening it to the attachment seat of the frame fixed to
the shell (Fig. 16). Then pull the chin strap left band towards the inside of the
helmet. Follow the same steps on the right side of the helmet.
NOTE: Check the correct assembly of the liner front area by lifting and lowering
the VPS. These movements should be smooth. If this is not the case, repeat
steps 11.5 and 12.2.
WARNING
- Remove the inner comfort padding only when cleaning or washing is required.
- Never use the helmet before completely and correctly reassembling its inner
comfort padding.
- Delicately hand-wash in lukewarm water (max. 30° C) and neutral soap.
- Rinse with cold water and allow drying at room temperature, away from direct
sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
- Do not modify or alter the helmet's internal polystyrene components in any way.
- Clean the inner components with a damp cloth only and allow it to dry at room
temperature away from direct sunlight.
- Never use tools or equipment of any sort to carry out the steps described
above.
WIND PROTECTOR
(Available as standard or accessory/spare part).
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector reduces unpleasant infiltrations of air under the chin.
See Fig. 22 for assembly and disassembly.
20