S&P PULSE 160 Manual De Instrucciones página 23

nting tube, pay attention to the power cable. Plug
in the fan (1). Push the fan unit down into the mou-
nting tube until the spacers touch the heat exchan-
ger (2).
Step 5: Reinsert the inside cover (air intake poin-
ting upwards) into the mounting tube.
7.2.3. Heat exchanger maintenance
Step 1: Pull the inside cover out of the mounting
tube.
Step 2: Unplug the fan (1). Pull the fan unit out of
the mounting tube using the strap (2), taking care
that the power cable is not damaged.
Step 3: Pull the heat exchanger unit out of the
mounting tube using the strap, taking care that the
power / sensor cable is not damaged.
Step 4: Clean the heat exchanger unit using a va-
cuum cleaner or wash with warm water. Only clean
the ceramic parts with water! Let the heat exchan-
ger dry.
Step 5: Reinsert the heat exchanger in the moun-
ting tube, taking care not to damage the cables in
the mounting tube.
Step 6: Reinsert the cleaned fan unit into the mou-
nting tube. Plug in the fan (1). Push the fan unit
down into the mounting tube until the spacers
touch the heat exchanger (2).
Step 7: Reinsert the inside cover (with the air in-
take pointing upwards) into the mounting tube.
23 23