Before Use - cecotec CONGA 1790 ULTRA Manual De Instrucciones

ENGLISH
1. Mode and time display
2. Time settings
3. Automatic charge/Back home
4. Auto cleaning/pause
5. Direction buttons
6. Spiral cleaning
7. Room cleaning
8. Scrubbing levels
9. Schedule
10. Edge cleaning
11. Power levels

2. BEFORE USE

Take the product out of the box.
Remove all packaging material Save the original box.
Make sure all parts and components are included and in good conditions. If any visible signs of
damage are observed, contact the Technical Support Service immediately.
Note: Remove all objects around the robot such as clothing, papers, cables, curtains or other
fragile objects.
Fig. 18
If the area to be cleaned has a balcony or stairs, a physical barrier must be placed in order to
prevent product damage and ensure safe operation.
Fig. 19
Direct exposure to sun light or great light contrasts may affect to the correct operating of the
sensors. If this happens and the robot stops, change it to a new location for it to start operating
again.
Place the charging base against the wall and leave a minimum free space of:
2 metres to the front.
1 metre to each side.
Fig. 20
Connect the charging base to a power supply. Wind and store the remaining cord in the lower
part of the charging base to avoid accidents.
Fig. 21
Install both side brushes in their corresponding slots, located on the robot's bottom part. Press
37