Technical Data - GreenWorks GPW2000-1 Manual Del Operador

EN
PROBLEM
The output pres-
sure varies high
and low.
POSSIBLE SOLUTION
CAUSE
The water supply Open water supply
is not sufficient. fully. Check gar-
den hose for kinks,
leaks, or blockage.
The pump is draw- 1. Make sure that
ing in air. the hoses and
fitting are air-
tight.
2. Turn "OFF"
machine.
3. Purge pump
by squeezing
trigger gun un-
til a stead flow
of water
comes out the
spray tip.
The water intake Remove the filter
filter is clogged. and Rinse in warm
water.
The supply volt- Make sure that on-
age is low. ly the pressure
washer is running
on the circuit.
The gun, hose or Run distilled vine-
nozzle are calci- gar through deter-
fied. gent tank.
English
PROBLEM
The motor buzzes,
but the machine
does not start.
There is no water.
11

TECHNICAL DATA

Universal Motor
Max. Pounds Per Square Inch
Pressure
Max Gallon Per Minute
Maximum Inlet Water Temper-
ature
Cleaning Units
Weight
12
POSSIBLE SOLUTION
CAUSE
The supply volt- Make sure that on-
age is low. ly the pressure
washer is running
on the circuit.
The pump system 1. Turn "OFF"
has residual pres- the machine.
sure.
2. Pull the spray
gun trigger on
spray wand to
release pres-
sure.
3. Turn the ma-
chine "ON".
Voltage loss due to Disconnect the ex-
use of an improper tension cord, and
extension cord. connect the ma-
chine directly into
the outlet.
Pressure washer Call customer
not used for long service.
periods.
Residual friction 1. Disconnect the
among compo- water supply.
nents. Unit might
2. Power "ON"
emit a humming
the machine
noise.
for 2 to 3 sec-
onds.
3. Repeat the
above step a
couple of
times or until
the motor
starts.
The water supply Turn the water
is off. supply on.
The garden hose is Remove kink in
kinked.. garden hose.
120V~ 60 Hz, 14 Amps
2000 PSI
1.2 GPM
104 °F (40 °C)
2400 C.U.
31 lbs. (14 kg)