Festool CS 70 VL Instrucciones De Montaje página 9

Folding away the extension table:
• Release rotary knobs (3.8).
• Loosen knurled nuts (3.3).
• Slightly raise the rear of the extension table and
remove ends of supports from slots.
• Fold supports in crosswise.
• Fold down extension table.
3 Ripping-cut fence CS 70 LA (1.3)
Precise sawing work with large work pieces is only
possible with a correctly fi tted ripping-cut fence CS
670 LA (Fig. 4).
The ripping-cut fence has separate clamps for the
front and rear edges of the table.
This prevents a lateral movement of the stop sur-
face.
The stop guide (4.7) can be fi tted to the stop rail
(4.5) as a high or low guide surface.
Rotate the stop guide by 90° and fasten to the cor-
responding guide grooves.
The following adjustments are possible with the
ripping-cut fence:
• Handle (4.2): Clamp stop to front edge of table
• Clamping lever (4.3): Clamp stop to rear edge of
table.
• Clamping lever (4.1): Clamp fi ne adjustment.
• Rotary knob (4.10): Stop adjustment with fi ne
adjustment
• Rotary knobs (4.6): Clamp stop guide to stop
rail.
Open the following clamps fully in preparation for
fi tting the fence:
• Clamp on front edge of table (4.2)
• Clamp on rear edge of table (4.3). (clamping lever
in a vertical upright position)
• Clamp on fi ne adjustment (4.21). (clamping lever
points towards switch)
• Then slid the fence over the table from the right
so that the clamp jaws of the front and rear
clamps lie below the peripheral table clamping
edge (4.4).
• The adjustment range for the fi ne adjustment an
be seen in the inspection window (4.9). Set a suf-
fi ciently large adjustment range for subsequent
adjustments with the rotary knob (4.10).
• Then slide the fence according to scale close to
the desired cutting width and clamp by fl ipping
the clamping lever (4.1) approx. 180° to the fi ne
adjustment.
If the clamp is too weak the clamping lever can
be moved as follows:
• Bring clamping lever into maximum clamping
position.
• Release bolt which holds the clamping lever to
the axis.
• Set clamping lever back by one division on the
hexagon.
• Re-tighten clamping lever.
• Set fence to exact size with fi ne adjustment using
rotary knob (4.10). The fence is hereby moved by
1/10 mm for every scale mark.
Tighten fence clamps (4.2 + 4.3) after fi nal adjust-
ment.
9