Swap Pan And Tilt; Pan/Tilt Speed; Wdmx Reset; Backlight Timer - Chauvet Professional MAVERICK MK1 SPOT Manual De Usuario

Ocultar thumbs Ver también para MAVERICK MK1 SPOT:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Swap pan and tilt

To switch the pan and tilt functions so that what normally controls the pan controls the tilt and what
normally controls the tilt controls the pan, follow the instructions below:
1. Navigate to the
Settings
2. Use <UP> or <DOWN> to select Swap XY, or touch the display where it says Swap XY.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (normal pan and tilt)) or YES (pan
controls tilt, tilt controls pan), or touch the display where it says the desired option.
5. Press <ENTER>.

Pan/tilt speed

To set the maximum speed of the pan and tilt:
1. Navigate to the
Settings
2. Use <UP> or <DOWN> to select XY Mode, or touch the display where it says XY Mode.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Slow or Fast, or touch the display where it
says the desired option.
5. Press <ENTER>.

WDMX reset

To reset the WDMX connection from the Maverick MK1 Spot, do the following:
1. Navigate to the
Settings
2. Use <UP> or <DOWN> to select WDMX Reset, or touch the display where it says WDMX Reset.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select NO (do not reset connection), YES (reset
the connection), or touch the display where it says the desired option.
5. Press <ENTER>.
Once a WDMX receiver has been linked to a specific WDMX transmitter, it will
remain linked to that specific transmitter until it is linked to a different one.

Backlight timer

To set the amount of time after inactivity before the display backlight turns off:
1. Navigate to the
Settings
2. Use <UP> or <DOWN> to select Backlight Timer, or touch the display where it says Backlight
Timer.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select 30S (after 30 seconds of inactivity), 1M
(after 1 minute of inactivity), 5M (after 5 minutes of inactivity), or ON (always on), or touch the
display where it says the desired option.
5. Press <ENTER>.

Loss of data

In case of an input signal being lost in any way, the Maverick MK1 Spot will respond in one of two ways:
The product will either hold the last signal received, or black out all LED output.
To set which way the product responds, follow the instructions below:
1. Navigate to the
Settings
2. Use <UP> or <DOWN> to select Loss of Data, or touch the display where it says Loss of Data.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Hold (hold last signal received) or Close
(black out all LED output), or touch the display where it says the desired option.
5. Press <ENTER>.
Page 18 of 191
menu.
menu.
menu.
menu.
menu.
Maverick MK1 Spot User Manual Rev. 9
Operation

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Maverick mr2 spot

Tabla de contenido