Installing A Paper Roll - Sharp XE-A201 Manual De Instrucciones

A201_1 01.11.11 10:20 AM
3.
Install three new R6 or LR6 batteries ("AA"size) as per the diagram.
When the batteries are properly installed "
4. Close the battery compartment cover.
4
Precaution: The paper cutter is mounted on the printer cover. Take caution when removing and
The register can print receipts or journals. For the printer, you must install the paper roll provided with the
register, even when you program the register for not printing receipts or journals.
Install the paper roll according to the procedure shown below with the power cord connected and the mode
switch set to the REG position:
1. Make sure the print head release lever is positioned as per the diagram.
2.
Cut off approximately one revolution of the paper roll. Make sure
the paper end is cut as per the diagram.
3.
Set the paper in paper roll cradle as per the
diagram.
4. Insert the end of the paper into the printer until it is caught by the printer
auto-feed and comes out of the top of the printer. If the printer does not
catch the paper, feed the paper while pressing the
8
Downloaded from: http://www.usersmanualguide.com/
Page 8
Be sure to observe precautions shown on page 1 when handling
batteries.

Installing a paper roll

installing the cover.
" on the display will disappear.
To the printer
Correct
F
key.
Correct Incorrect
To the printer
Incorrect