Handle Installation; Description Of The Product Features; Using Your Wine Cooler - Cavist 48 Manual De Usuario

Bodega - 48 botellas
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 44

HANDLE INSTALLATION

To install the door handle follow the below steps:
1. Open the door of the appliance and move the door gasket
slightly to one side so that you can see two designated holes for
handle installation
2. Install the handle tightly as shown in the diagram above with the
two screws provided.
3. Ensure the door gasket falls back into place and that the door
opens and closes correctly.

DESCRIPTION OF THE PRODUCT FEATURES

1) Control panel
o The control panel is located at the top of the appliance, it is very easy to set the temperature of
the appliance and see what temperature the appliance is set to.
2) Interior light
o The wine cooler has an interior light. The light can be switched on and off by using the light
control button.
3) The wine cooler shelves
o The shelves are fully adjustable to suit various wine bottle shapes and sizes.
o To prevent damaging the door gasket, make sure the door is fully open when pulling shelves out
of the rail compartment.
For easy access to the bottles stored, pull the shelves out approximately 1/3. The shelves are
designed with an emergency stop to prevent them being removed too far when loaded.

USING YOUR WINE COOLER

Before switching on
o Make sure that it has been installed by a suitably qualified person, as per the information
contained in the installation instructions.
o After delivery, wait for four hours before connecting the appliance to your mains supply. This will
allow any refrigerant gasses that may have been disturbed during the transportation process to
settle.
o The outside of the appliance and the removable accessories contained within it, should be
cleaned with a solution of liquid detergent and water.
o The interior of the appliance should be cleaned with a solution of sodium bicarbonate dissolved
in lukewarm water. The interior and accessories should be thoroughly dried, after the cleaning
process has been completed.
o There can be an odour when you first switch on the appliance. It will lessen as the appliance
starts to cool.
During first use
IMPORTANT: When you use the wine cooler for the first time or restart the appliance after it has
been turned off for a long time, there could be a few degrees variance between the temperature

Publicidad

Tabla de contenido
loading

Tabla de contenido