Error Codes - Starblitz ASPIC Manual De Usuario

EN
How to use Starblitz® ASPIC flash with other flash light
1. Match Starblitz® ASPIC with other series of studio flash (ABEJA200, SHARK400)
FR
from Starblitz®: Use SST-801TX or SST-816TX transmitter, connect Starblitz® ASPIC
with SST-816RX radio receiver, realize flash trigger(Flash power and model lamp of
Starblitz® ASPIC can't be controlled by SST-801TX).
ES
2. Match Starblitz® ASPIC with other series of studio flash (ABEJA200, SHARK400)
from Starblitz®. Use SST-818TX transmitter, realize flash trigger and power adjust-
ment together (modeling lamp of other series of studio flash from Starblitz® can't be
controlled by SST-818TX ).
3. Match Starblitz® ASPIC with Starblitz® speedlite, use speedlite as master flash or
use SST-818TX transmitter, can realize flash trigger and power adjustment.
4. Match Starblitz® ASPIC with hot shoe mounted (multi-contact) TTL studio flash
or speedlight from other brand: Use SST-818TX transmitter, connect with hot shoe
mounted (multi-contact)TTL studio flash or speedlight from other brand with SST-
818RX receiver, realize flash trigger and power adjustment.
5. Match Starblitz® ASPIC with single contact speedlite or studio flash from other
brand, use SST-818TX trigger and SST-818RX receiver to realize flash trigger.

Error codes

E1 : Temperature Transducer problem. Turn the unit OFF immediately and contact
the place where you purchase the flash.
E2: This error code can display after a long shooting session at high output or rapid
sequence. Flash will make alarm, reminding user to cool it before operate it again.
Turn OFF the flash and allow it to rest 30 minute
E3: This error code will display when the internal voltage of the flash is too high. Turn
OFF the power immediately. After a few minutes, turn on the flash again. If you still
have the malfunction warning, turn OFF the unit and contact the place where you
purchased the flash.
E4: Internal charging problem. Turn off flash light immediately, and contact the place
where you purchased the flash.
Low voltage protection: Before battery running out, battery signal on the LCD
screen will blink . Please charge batter y as soon as possible. If not charge the battery
in time, power of the flash will cut off automatically when battery voltage is lower
than 8.6V.
18