Juguetronica MICRO HEXADRONE VCAM HD Manual De Instrucciones página 10

TRIMMING OF THE MICRO HEXADRONE
TRIMMING FORWARD
AND BACKWARD
When the micro hexadrone
tends to be displaceable
forward in steady flight,
press the button trimming
backward as many times
as necessary to correct the
flight. If it tends to retreat,
does the same with the trim-
ming of forward.
FUNCTIONS OF THE MICRO HEXADRONE
Low charge protection:
When the micro hexadrone battery is not sufficiently charged, the motors in-
terrupt their power supply and the drone does not take off. It is an automatic
battery protection.
Hard Reset:
When the drone flies uncontrollably and trimming not correct these errors flight, it is best to per-
form a reset to return to the drone of the original factory settings. This setting lets the drone with the
manufacturing settings it had when you bought it. To perform the hard reset, the following steps:
1. Connect the battery to the micro hexadrone (Image 1).
2. Connect the control by moving the switch to the "ON" position (Image 2).
3. When the LED indicator of the micro hexadrone stops flashing quickly to flashing more slowly,
pushing the power lever (left) to highest position and then to the lowest position (Image 3). Then
the LED indicator micro hexadrone stops flashing slowly to keep the lights fixed.
4.Now, place the micro hexadrone on a flat, horizontal surface. Takes control and pushes the
levers to the bottom right corner for 2-3 seconds (Image 4), so the LED indicator of the micro
hexadrone starts flashing rapidly. After 2-3 seconds, the LEDs of the micro hexadrone return to
light steadily. The Hard Reset factory settings is completed correctly.
Acrobatic mode:
When you've controlled the flight and the basic operation of the drone, you're
ready to perform some tricks and impressive stunts.
The first thing is that the flight is always keep a greater height of three meters,
since all the stunts lead to a loss of height, and so will avoid the drone hit against
the ground. To perform acrobatics, you have to press the "aerobatic" (button
located on the front right) and then push the direction lever (right) in the direction
you want to do a stunt 360.
ADVICES ABOUT THE FLIGHT MODE ACROBATIC:
Confirm that the battery charge is enough when you are performing acrobatics.
TRIMMING LATERAL
When the micro hexadrone
tends to displaceable left in
stationary flight, press the
right displacement button
trimming. If it tends to go
right, do the same with the
left trimming.
1
DISPLACEMENT
2
TRIMMING TURN TO
THE RIGHT LEFT
When the micro hexadrone
tends to turn to the left in sta-
tionary flight, press the rota-
ting trimming right as many
times as necessary to correct
the flight. If it turns right, do
the same with the left turning
trimming.
3 4