Juguetronica MICRO HEXADRONE VCAM HD Manual De Instrucciones página 8

PARTS OF THE CONTROL
Absolute
control
Off - Power
indicator
Up / down
Turn right
Turn left
Trimming turn to
the left
BATTERY INSTALLATION IN THE CONTROL
1.5V AA
DEPARTURE
1. Connect the battery to the micro hexadrone
ADVICE:
When you synchronize your
horizontal surface so that the flight is stable.
PRECAUTIONS
1. When the control LED remains on but the LED micro hexadrone flashes slowly, it indicates that
synchronization has not been performed correctly. Turn off the control and the micro hexadrone
and back to "departure" from the beginning.
2. If when start flying the micro hexadrone not maintained stably, lands, off the control and
hexadrone, and returns to sync it with special attention so that it is placed on a flat, horizontal
surface.
3. If the LED micro hexadrone flashes slowly, the battery is running out. Lands and charge the
hexadrone battery with the USB charger provided.
Automatic
Return home
Charge
indicator
Trimming turn to
the right
Battery cover
1.5V AA
3. When the LED indicators of micro hexadrone pass from a quick blink
at a slow, pushing the power lever (left) to the highest position and then
move it to the lowest position. The control will emit a beep to confirm
that the synchronization was successful and the drone is ready to fly.
Micro Hexadrone vCam HD, be sure that it is on a flat,
Power
Trimming
indicator
to forward Trimming to
Trimming of displacement
to the left
Remove the battery cover with a screwdriver,
screws. Put 4 "AA" batteries (not included),
2 on each side of the control, and put the
battery cover again and screws it.
1. Place the batteries according to the polarity.
2. Do not mix new and exhausted batteries.
3. Do not mix different types of batteries.
2. Connect the control
backward
Capture
Photo / Video
Forward / Backward
Displacement to the
Right / Left
Button stunts
Trimming of
displacement to the
right