Replacing The Lamp Wine Cellar - AEG SWD81800G1 Manual De Instrucciones

Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
dEMo appears on the
Display.
Upper or lower
square is shown in
the temperature Dis-
play.
REPLACING THE LAMP WINE
CELLAR
Disconnect the mains plug from the mains
socket.
Possible cause
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
Many bottles are stored at
the same time.
There is no cold air circula-
tion in the appliance.
The appliance is in dem-
onstration mode (dEMo)
An error has occurred in
measuring the tempera-
ture.
Remove the lamp cover by pressing it in-
wards with a tool (e.g. screwdriver) to free
the rear side hookings.
ENGLISH
Solution
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the
door".
Store less bottles at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Keep pressed approximate-
ly 10sec the Alarm button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
15