LaserLiner SuperCross-Laser 2P Manual De Instrucciones página 10

! The transport restraint must be released for horizontal and vertical levelling. The laser lines flash and the LED
lights red as soon as the device is outside the automatic levelling range of 4°. Position the device such that it
is within the levelling range. The LED switches back to green and the laser lines stop flashing (steady light).
4
Slope mode
Do not release the transport restraint, set the ON/OFF switch to „OFF". Select and switch on
the laser with the selection button. Sloping planes can now be measured. This mode cannot
be used to perform horizontal or vertical levelling as the laser lines are no longer aligned auto-
matically. The LED lights constantly red.
Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning agents, scouring agents and solvents.
Remove the battery(ies) before storing for longer periods. Store the device in a clean and dry place.
Technical data
(Subject to technical alterations. 09.17)
Automatic levelling range
Accuracy
Operating range (depending on room illumination)
Working range with hand-held receiver
Laser wavelength
Laser class
Power supply
Operating time
Operating conditions
Storage conditions
Dimensions (W x H x D)
Weight (without wall bracket and batteries)
EU directives and disposal
This device complies with all necessary standards for the free movementof goods within the EU.
This product is an electric device and must be collected separately for disposal
according to the European Directive on waste electrical and electronic equipment.
Further safety and supplementary notices at: http://laserliner.com/info?an=supcrolas2p
10
EN
± 4°
± 0.5 mm / m
20 m
depending on receiver: 30 to 50 m
635 nm
2/≤ 1 mW
4x 1.5V batteries (type AA, LR6)
approx. 25 hours
0 ... 50°C, Max. humidity 80% rH, no condensation,
Max. working altitude 4000 m above sea level
-10 ... 70°C, Max. humidity 80% rH
66 x 119 x 124 mm
0,43 kg