Glossary - Eaton Pulsar Serie Manual De Instalacion Y Uso

8. Appendices

Glossary

Backup time
Bypass AC source
Equipments
Frequency converter
Low-battery
warning
Manual bypass
Normal AC source
Normal (double
conversion) mode
Personalisation
Programmable
outlets
Relay contacts
UPS
-
34008486EN/AC Page 44
Time that the connected equipments can operate on battery power.
Source supplying the bypass line. The equipments can be transferred to the bypass line if
an overload occurs on the UPS output, for maintenance or in the event of a malfunction.
Devices or systems connected to the UPS output.
Operating mode used to convert the AC-power frequency between the UPS input and
output (50 Hz -> 60 Hz or 60 Hz -> 50 Hz).
This is a battery-voltage level indicating that battery power is low and that the user must
take action in light of the imminent break in the supply of power to the load.
Rotary switch controlled by the user, used to connect the equipments directly to the AC
source. Transfer of the equipments to the manual bypass enables UPS maintenance
without interrupting the supply of power to the connected equipments.
Normal source of power for the UPS.
The normal UPS operating mode in which the AC source supplies the UPS which in turn
supplies the connected equipments (after electronic double conversion).
It is possible to modify certain UPS parameters set in the factory. Certain UPS functions
can also be modified by the EATON power management products to better suit user needs.
These outlets can be automatically shut down during operation on battery power
(shutdown time delays can be programmed with the EATON power management
products). The UPS has two sets of two programmable outlets.
Contacts supplying information to the user in forme of signals.
Uninterruptible Power System.