Troubleshooting - Glomex URANIA 2 V9331 Manual Instalación Uso Y Mantenimiento

URANIA 2 V9331 - PANDORA V8001 - RHEA V8100

10. TROUBLESHOOTING

When a malfunction of your satellite system
occurs, it is very important to make a rapid check to
understand the nature of the malfunction and, if
possible, to find a remedy.
To analyze a malfunction, it is appropriate to carry
out the following verifications:
- the malfunction has been generated through
human mistake;
- the malfunction is due to a weather problem;
- the malfunction is due to a failure of the equip-
ment itself or it is caused by an anomaly of
another external appliance, but in some ways
connected to the equipment;
- in which phase the malfunction occurs: upon
start-up, during normal operation, upon shut-
down;
- the malfunction is repeated; if so, according to
what criteria;
- what the malfunction determine from a func-
tional point of view;
Anomaly
1. The antenna does not operate
(the led on the control unit
does not turn on)
2. The antenna does not operate
(the led on the control unit
flashes alternately red and
green)
3. No status message on the
decoder
4. No image on the TV (the led
on the control unit is green)
- whether the malfunction produces signals (light
signals) and/or anomalous noise (such as hiss-
ing, buzzing, etc.) and/or anomalous odours
(smell of burning) or not;
- the malfunction interferes with the operation of
other appliances;
- the malfunction is an apparent failure (i.e. it dis-
appears, for example, by turning off and then on
again the equipment).
The better you are able to answer the above-men-
tioned questions, the deeper the malfunction analy-
sis will be.
The following table analyzes the most probable
causes which can lead to malfunctions of your
GLOMEX URANIA 2 V9331, PANDORA V8001
and RHEA V8100 antennas. For any analyzed pos-
sible cause, a corrective measure is proposed, to
efficiently solve, as much as possible, the trouble.
Cause
- the fuse is blown
- wrong power supply cable
connection
- short-circuited coaxial cable
- proper failure
- the coaxial cable has loosened
or has disconnected from the
antenna
- inner failure
- the satellite receiver is not
installed correctly
- alternating current fluctuations - refer to the user manual of the
- the receiver is off
- the TV set is off or has not
been tuned to AV
- wrong cable connection on the
receiver
- the channel list is not up-to-
date
64
Remedy
- replace the blown fuse with a
new one (see section "Mainte-
nance")
- check the polarity on the
power supply line
- check the correct mounting of
the coaxial cables
- contact the Service Centre
- check the connection of the
coaxial cables
- contact the Service Centre
- check the receiver connection
receiver for support
- turn off the control unit, turn on
the receiver and then turn on
the control unit again
- turn on the TV set and tune to
AV channel
- check that the SCART socket
between the TV set and the
receiver is installed correctly
- carry out the automatic channel
search in the receiver menu
www.glomex.it