Descargar Imprimir esta página

BH FITNESS H495 Instrucciones De Montaje Y Utilización página 10

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
adjust the position of the saddle post
and tighten the knob (18) by turning it
clockwise.
6.- ADJUSTING SADDLE HEIGHT.-
Loosen the saddle height control knob
(18) a little, Fig.5, turning it anti-
clockwise and then pulling it back,
when the saddle is at the right height
release the control knob and this will
lock back into the holes on the saddle
post. Tighten the control knob by
turning it clockwise.
7.- FITTING THE HANDLEBAR.
Loosen the handlebar bracket (12),
line the handlebar (7) up with the main
post (58), Fig.6.
Pass the hand-grip cables (6) through
the slot on the post (58) Fig.6, and pull
them out through the top.
Insert the handlebar (7) in the bracket
(12) of the main mast (58) Fig.6 Set
the
handlebar
position and tighten the handle (10)
turning clockwise, Fig.6.
8.- FITTING THE ELECTRONIC
MONITOR.-
Remove the screws (9) from the base
of the monitor, connect the terminals
for the feedback cable (54D) to those
on the monitor (1), Fig.7, then slide
the front of the monitor down onto the
plate on the main post (58), making
sure not to snag any of the wires, fit
the screws (9) and tighten, plug the
terminal for the handgrip (6) Fig.7.
in
a
comfortable
Insert the trim covers (2L) and (2R)
through the ends of the handlebar (7)
Fig.7.
Fix them with the screws (3), Fig.7.
9.- LEVELLING.-
Once the unit has been placed into its
final position for doing exercise, make
sure that it sits flat on the floor and
that it is level. This can be achieved by
screwing
the
blocks (34) up or down, as shown in
Fig.8.
10.- MOVEMENT & STORAGE.-
The appliance is equipped with wheels
(19) making it easier to move about.
The two wheels at the front of the
appliance make it easy to store the
machine away, as shown in Fig.9.
11.-MAINS CONNECTION.-
Insert the jack (g) on the transformer
(61) into the connection hole (h) on
the main body (52) (bottom, rear of the
machine)
transformer into a 220 V mains supply,
Fig.10.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
10
adjustable
and
then
plug
support
the

Publicidad

loading