Tools Required For Assembly; A Hex Bolt, 5/16-18 X 3-3/4; B Hex Bolt, 1/4" X 1/2; C Hex Bolt, 3/8" X 1 - SpeedEPart Agri-Fab 45-01841 Manual Del Usuario

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1) Screwdriver
(1) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrench
(2) 9/16" Wrenches
1. Remove the hardware pack and all loose parts
from the carton. Be sure the carton is empty
before discarding.
2. Lay out all the parts as shown in the carton con-
tents.
DO NOT LEAVE THE CART UNATTENDED IN
UPRIGHT POSITION DURING ASSEMBLY. A
FALLING CART CAN CAUSE PERSONAL INJURY!
PAY CLOSE ATTENTION TO THE STABILITY OF
THE CART WHILE IT REMAINS IN AN UPRIGHT
POSITION. FOR BEST STABILITY, ASSEMBLE
ON A SMOOTH, LEVEL SURFACE.
3. Position cart body halves upright on a smooth
level surface such as a garage floor or a paved
driveway. See figure 2.
4. Assemble halves together using three 1/4" x 1/2"
hex bolts and 1/4" hex nuts as shown in figure 2.
Do not tighten yet.
Note: The 45-01841 and 190-425A carts use four
bolts and nuts.
1/4" x 1/2" HEX BOLT
FIGURE 2
CAUTION
1/4" HEX NUT
www.mymowerparts.com
ENGLISH
5. Position the tailgate reinforcement bracket on
outside of cart as shown in figure 3. Assemble to
the bottom of the cart body using four 5/16" x 3/4"
truss head bolts and 5/16" hex nuts. Do not tighten
yet. See figure 3.
6. Position the tailgate guides on the inside of the
cart bodies with guide channels to the front as
shown in figure 3. Assemble using four 1/4" x 1/2"
hex bolts and 1/4" hex nuts. Do not tighten yet.
See figure 3.
5/16" HEX NUT
FIGURE 3
7. At this time, with the cart body halves pulled
together, tighten the four truss head bolts
assembled in step 5 and then the four hex bolts
assembled in step 6. Leave loose for now the bolts
that were assembled in step 4.
8. Carefully reverse the position of the cart so that it
rests on the end with the just assembled tailgate
reinforcement bracket, as shown in figure 4. Proceed
with the assembly steps which follow.
FIGURE 4
4
1/4" HEX NUT
TAILGATE GUIDE
1/4" x 1/2"
HEX BOLT
5/16" x 3/4"
TRUSS HEAD BOLT
TAILGATE
REINFORCEMENT
BRACKET