Tools Required For Assembly - SpeedEPart Agri-Fab 45-0518 Manual Del Usuario

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(2) 7/16" wrenches
(2) 1/2" wrenches
(2) 9/16" wrenches
(2) 3/4" wrenches or adjustable wrenches
Before assembling the aerator, lay out all the parts
and hardware as shown on previous pages.
CAUTION:
KNIVES ARE SHARP! EXERCISE
CAUTION AT ALL TIMES WHILE
ASSEMBLING AND USING THE
AERATOR.
1. Attach the lift lever assembly to the two holes in the
middle of the shaft using two 1/4" x 1-3/4" hex bolts
(B) and a 1/4" nylock nuts (K). Tighten. See figure 1.
1/4" x 1-3/4"
HEX BOLT (B)
FIGURE 1
POINTS OF AERATOR
LIFT LEVER ASSEMBLY
1/4" NYLOCK
NUT (K)
ENGLISH
2. Push split plastic bearings (X) into both ends of all
single and double spool assemblies. See figure 2.
SPLIT
BEARING (X)
FIGURE 2
3. Identify the short end of the shaft. Assemble a 1"
long spacer (S), a single spool assembly, a 1.33" long
spacer (T), a double spool assembly, another 1.33"
long spacer (T) and a 3/4" flat washer (N) onto the
short end of the shaft. See figure 3.
3/4" FLAT
WASHER (N)
DOUBLE SPOOL
ASSEMBLY
FIGURE 3
4
SPLIT
BEARING (X)
SPLIT
BEARING (X)
1.33" LONG
SPACER (T)
1.33" LONG
SPACER (T)
SHORT END
SINGLE SPOOL
OF SHAFT
ASSEMBLY
SPLIT
BEARING (X)
1" LONG
SPACER (S)