Compliance Statement - Espa ACUAPLUS N Serie Manual De Instrucciones

Instruction Manual
Problems
4
5,6
1
1
1,3
2,4,7
1,8
1,8
1
1,4
4
2,7
1
9. List of main components and sizes.
The materials used are top quality, submitted to strict controls and checked with maximum thoroughness.
The list of the main components can be seen in Fig. 8.
10.

Compliance Statement

PRODUCTS: ACUAPLUS
The products indicated above comply with:
Machinery Directive 2006/42/EC and Standard EN 809, Low-Voltage Directive 2006/95/EC and Standard EN 60335-2-41,
EMC Directive 2004/108/EC.
Signature/Position:
Causes
Turbines worn down
Water temperature
Incorrect programming
Insufficient water detected
Insufficient water
Water loss through discharge line
Thermal protection error
Stop caused by level probes
Supply cable cut
Capacitor improperly connected
A gate valve closed
Water loss through installation tap
Water column is higher than the
default pressure
Pere Tubert (Technical Office Manager)
Solutions
Disassemble it and take it to an
Official Technical Service
Work with an appropriate
temperature
Revise the programming
Reset the control and find out why
there is insufficient water
Wait for the water level to be
restored and press the reset button
Repair the leak
Reset the thermal protector or wait
until it cools down
Wait until the well level is restored
Check electrical cable
Revise the connection according
to the diagram provided
Open the valve
Repair the leak
Revise the default pressure
adjustment
(Figures 7-8)
11