Assembly - Delta 50-720 Manual De Instrucciones

UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from
unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your
machine.
After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
HOW TO ATTACH THE CASTERS
Each of the casters is embedded with a bolt (A) Fig. 1. Screw the bolt end of each caster into the tapped holes on the
bottom of the base (Fig. 2) . Tighten each one securely.
A
HOW TO ATTACH THE SIDE SUPPORTS
1. Place the dust collector base (A) Fig. 3 upright.
2. Align the two holes (B) in the side support (end with the Delta logo) with the two holes in the base.
3. Insert a 5/16-18 x 5/8" hex head bolt (B) Fig. 3 through each hole in the side support and base (A).
4. Place a 5/16" lockwasher on the hex-head bolt.
5. Thread a 5/16-18 hex nut on the hex-head bolt and tighten securely.
6. Repeat this process for the remaining side support.
7. Use four 5/16-18 x 5/8" hex head screws, lockwashers and nuts to secure
the side supports (B) Fig. 4 and curved side supports (A) together.

ASSEMBLY

ASSEMBLY TOOLS REQUIRED
12mm and 13mm Wrench, Open-End or Socket.
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately 1-2 hours.
Fig. 1
B
A
Fig. 3
7
Fig. 2
A
B
Fig. 4