Symbols On The Product - GreenWorks MO13B00 Manual Del Operador

jacketed cords listed by Underwriter's Laboratories (UL)
should be used.
When working outdoors with a product, use an extension cord
that is designed for outside use. This type of cord is
designated with "W-A" or "W" on the cord's jacket.
Before using any extension cord, inspect it for loose or
exposed wires and cut or worn insulation.
A proper extension cord is available at an authorized service
center.
It is possible to tie the extension cord and power cord in a
knot to prevent them from becoming disconnected during use.
Make the knot as shown in the figure, then connect the plug
end of the power cord into the receptacle end of the extension
cord. This method can also be used to tie two extension cords
together.
Minimum Gauge for Extension Cords (AWG)
(when using 120 V only)
Amp Rating Total Length of Cord in Feet (meters)
Not
More 25' (7.6
More
Than m)
Than
0 6 18
6 10 18
10 12 16
12 16 14
Keep the extension cord clear of the working area. Position
the cord so that it will not get caught on lumber, tools, or
other obstructions while you are working with a power tool.
Failure to do so can result in serious personal injury.
Check extension cords before each use. If damaged replace
immediately. Never use the product with a damaged cord
since touching the damaged area could cause electrical shock
resulting in serious injury.
4

SYMBOLS ON THE PRODUCT

Some of the following symbols may be used on this tool.
Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the
tool better and safer.
Symbol Name
V Volt
A Amperes
English
150'
50' (15 100'
(45.7m)
m) (30.4 m)
16 16 14
16 14 12
16 14 12
Not Recommen-
12
ded
Explanation
Voltage
Current
Symbol Name
Hz Hertz
W Watt
min Minutes
/min Per Minute
Alternating
Current
Direct Current
No Load
n o
Speed
Safety Alert
Eye Protec-
tion
WARNING
--- Wet Con-
ditions
Read Opera-
tor's Manual
Maintain
Safety Devi-
ces
Looking Be-
hind While
Backing
DANGER ---
Keep Hands
and Feet
Away
DANGER ---
Keep By-
standers Away
DANGER ---
Thrown Deb-
ris
7
Explanation
Frequency (cycles per sec-
ond)
Power
Time
Revolutions, strokes, sur-
face speed, orbits etc., per
minute
Type of current
Type or a characteristic of
current
Rotational speed, at no load
Precautions that involve
your safety.
Always wear eye protection
with side shields marked to
comply with ANSI Z87.1
when operating this equip-
ment.
Do not expose the product
to rain or moist conditions.
To reduce the risk of injury,
user must read and under-
stand operator's manual be-
fore using this product.
Do not open or remove
safety devices while the
tool is running.
Look down and behind first
to avoid tripping when pull-
ing back.
To reduce the risk of injury,
keep hands and feet away
from rotating parts. Do not
operate unless discharge
cover or grass bag is in its
proper place. If damaged,
replace immediately.
All visitors should be kept
at a distance from work
area.
Remove objects that can be
thrown by the blade in any
direction. Wear safety
glasses.
EN