Using The Blender - Hamilton Beach Tango Serie Manual De Uso

840080600env03 10/24/01 10:07 AM Page 5
Operation
Operating the Blender–Model 91300
wWARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or
electrical shock.
Controls
Two separate switches on the front panel
allow you to control the blender for precise
blending requirements:
• The On/Off switch will turn the blender
On for continuous operation or Off.
• The Pulse position on the On/Off
switch (Model 91300 only) turns on the
blender only when the switch is pressed.
When the switch is released, the blender
will stop. This will allow you to precisely
control the operation of the blender.
• The Hi/Low switch allows you to select
the following speeds:
Hi – 20,000 RPM Low – 18,500 RPM

Using the blender

Before you use the blender for the first
time, wash the container, cover, and
cutter unit assembly. Refer to "Cleaning
Instructions." Do not put the cutter
assembly in the dishwasher.
To operate the blender, proceed as follows:
1. Place the blender on a clean, dry, level
surface, and set the On/Off switch to Off.
2. Place cutter unit in the threaded collar,
blades up. Slip the gasket OVER the
blades and onto the base of the
cutter assembly. Screw the completed
cutter assembly onto the container.
wWARNING
Cut Hazard
Always place cover on container
before operating blender.
Do not put spoon or other utensils
in container when blending.
Failure to follow these instructions
can result in broken bones, cuts, or
other injuries.
On (I) /
Off (O) /
Pulse
Switch
Model 91300
3. Plug the blender into an electric outlet.
4. Place the ingredients to be blended into
the container.
5. Place the container onto the base. Make
sure it rests securely on the base.
6. Place the cover and filler cap on the
container.
7. Set the Hi/Low switch to the desired
speed. See "Professional Blending
Techniques" for blending tips.
NOTE: If you want the blender to run for
short bursts, press the
While you are pressing the
the blender will run at the selected speed.
Release the Pulse switch to stop the blender.
Hi/Low
Switch
Pulse switch.
Pulse switch,
5