BFT Espas30 I Manual De Uso página 39

Volum Description
RITPA This parameter sets some tenths of
a second delay.
AftrC This parameter sets a tens of sec-
onds delay between the barrier
closing and the activation of the sta-
tion inactive status. The parameter
is used to prevent other cars from
approaching the entrance / exit
while the barrier is closing. It is used
when, for instance, there is a ramp
with no visibility after the barrier.
IOPZ7 Configuration of optional entrance
7 YES = station enabling; NO = high
vehicle photocell
2CARS Station behaviour in a queue If =
YES, the station deals with the fol-
lowing vehicle without waiting for
the barrier to close.
InvBr Barrier behaviour while closing If
= YES, the barrier does not need to
close completely to open again.
RepCl Repetition of the closing command.
Necessary for some barrier models.
Retra Retractor management on exit.
Valid only if GateT = Exit.
NO = Barcode reading on exit with
scanner.
YES = Barcode reading on exit with
motorized module.
AdlCP If this parameter is set on "YES", the
retractor catches the valid ticket
and holds it inside the station.
NO: the retractor rejects the ticket
after reading it
YES: the retractor catches and holds
the ticket after reading it
AdlP1 This parameter allows setting the
reading position of the ticket bar-
code #1. The value to set depends
on the ticket layout.
AdlP2 This parameter allows setting the
reading position of the ticket bar-
code #2. The value to set depends
on the ticket layout.
AdlBm This parameter shows the angle
of the ticket reading head. It is not
modifiable
TfTDi This parameter shows if a TFT dis-
play is installed in the station. NO:
TFT display not installed YES: TFT
display installed
Values
0..........300
NO/YES
NO/YES
NO/YES
NO/YES
NO/YES
NO/YES
200.....700
200.....700
330
Default
000
000
NO
NO
NO
NO
NO
-
330
330
330
Espas30 I - 39