Technical Data - Vetus RWPANEL2 Manual De Uso

Wiper motors
Use only wiper motors of the same type; wiper
motors must be equipped with an automatic
park setting.
The wiper motors used must have 2 speeds to
be able to use both low and high speeds. For ex-
ample, VETUS type RWS and HDMC. VETUS type
ORW is not suitable.
Connect the wiper motors to the controller
unit as indicated in the diagram. Use connect-
ing wires with a sufficiently large diameter.
(See the connection diagram on p. 22 for the
recommended wire diameter).
Panel
Connect the control panel to the control unit as
described in the diagram. The connector wires
should have a core cross section that corre-
sponds to the core cross section as indicated.
Washer
A water pump or magnetic valve can be con-
nected to the WASHER connection for a washer.
The current for which the water pump or
magnetic valve are suitable must correspond
to the onboard current (12 or 24 V)
Rain sensors
Consult the manual provided with the rain sen-
sors to determine how to install them.
Safeguards
Each wiper motor is individually protected by
a fuse. The washer pump is also protected by
a fuse.
These fuses are under the lid of the controller
8
101005.01
N !
ote
N !
ote
unit (see diagram below on how to remove lid).
See 'Technical data' for fuse values.
4

Technical data

Current
12 or 24 V DC
Current received *): approx. 11 mA
Number of wipers: 3 max.
Maximum wiper motor output: 120 watts
Internal fuses
Wiper motors: 10 A (3 x)
Wiper pump or valve: 5 A (1 x)
*) The control panel and control unit only, the
controller unit only, not including current used by
wiper motors.
vetus® Windscreen wiper controller