Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING INSTRUCTIONS
Base and Standing Shaft Assembly
1. Attach the lower standing shaft onto the standing base. Use screws and washers to fix the shaft firmly.
2. Insert the upper standing shaft into the lower standing shaft, turning the upper standing shaft clockwise to
tighten the connection of two shafts.
The Whole Assembly
1. Remove the blade fastening screw and guard fastening screw from the motor shaft spindle.
2. Fit the rear guard by positioning with the location pins. Secure the guard onto the motor body with the guard
fastening screw.
3. Place the fan blade onto the motor shaft by matching the slot with the shaft pin. Fix the blade by tightening
the blade fastening screw in a counter-clockwise direction. Check that the fan blade can rotate freely by
turning it with your hand.
4. Put the front guard against the rear guard and fix with the clamping ring. Make sure the clamping ring is set
properly at the rim of the fan guards. Tighten the screw on the clamping ring.
OPERATION
Connect the appliance to a suitable power source. Then press the control panel or the remote control to choose
your desired functions.
1. ON/off: Press "
normal / Timer: off / Swing: off
Press "
" again to turn off the appliance.
2. SPEED: Press "
"1": low wind; "2": Medium wind; "3": high wind
3. MODE: Press "
1) Normal: under this mode, you can press "
2) Natural: under this mode, the appliance will operate as follows:
5 seconds medium wind → 5 seconds low wind → 5 seconds medium wind → 5 seconds high wind → 5
seconds medium wind → 5 seconds low wind → stop 3 seconds ... (Repeating)
3) Sleeping: under this mode, the fan will operate as follows:
5 seconds medium wind → 10 seconds low wind → 5 seconds medium wind → 5 seconds low wind → 5
seconds medium wind → 10 seconds low wind → stop 3 seconds ... (Repeating)
Note: In natural mode or sleeping mode, the motor works with the preset speed. That is, the speed button
cannot control the speed under these two modes.
4. TIMER: Press "
elapsed, the fan will be off and under standby condition.
5. SWING: Press "
6. Tilting angles: By pushing the fan-guard, you can adjust the fan to the preferred elevation.
CLEANING
1.
Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains cable
from the socket.
- 21 -
" to turn the appliance on. It will work with the following presetting: Speed: low / Mode:
" to adjust the speed.
" to choose the mode functions from Normal →Natural → Sleeping → ... (Repeating).
" to set your desired working time from 1h →2h →3h ... →7h →off. When the set time has
" to control the oscillation function on or off.
" to choose speed Low /Mid /High.
80.06.0021
Publicidad
