Fagor CAT 40 NG Instrucciones De Uso página 34

GB
• Do not use steam to heat inflammable
liquids!
• Only use the coffee machine with
water in the system! Fill the water tank
with cold water. Do not use hot water,
milk or other liquids. Do not exceed the
maximum fill level of 1.5 litres.
• Do not put frozen or caramelised cof-
fee beans in the bean container. Use
only roast coffee beans! Remove any
foreign bodies from the coffee beans.
Failure to do this invalidates the guar-
antee.
• Spoon only ground coffee into the
ground coffee filler.
• Do not leave the coffee machine
switched on unnecessarily.
• Do not expose the coffee machine to
the weather.
• When using an extension lead, use only
a commercially available cable with a
conductor cross-section of at least
1.5 mm².
• To avoid injury, persons with motor
system disorders should never use the
machine without an accompanying
person.
• Operate the machine only when the
drip tray, container and the drip grille
are installed!
Safety in cleaning and care
• Follow the cleaning and descaling
instructions.
• Switch off the coffee machine and
unplug from the mains socket before
carrying out any maintenance or
cleaning!
• Do not immerse the coffee machine in
water.
• Only clean the steam nozzle when the
machine is switched off, cold and not
under pressure!
• Do not clean coffee machine parts in
the dishwasher.
• Never put water in the grinder. This
would damage the grinder.
34
Never open or repair the coffee
machine. Faulty repairs can result in
considerable hazard to the user.
Repairs to electrical appliances must be
carried out only by qualified service
engineers.
If a repair becomes necessary – includ-
ing replacement of the mains lead,
please contact
• the dealer where you bought the cof-
fee machine, or
• To Fagor's customer care service.
If the coffee machine is used incor-
rectly, or for a purpose other than its
intended purpose, we cannot accept
any liability for damage caused or
any guarantee claims. This provision
also applies if the cleaning and des-
caling programs are not run in accor-
dance with the instructions in this
manual, immediately after illumina-
tion of the "Clean" key (Fig. 3, k)
or the "Descale" key (Fig. 3, j) .