Running The Cleaning Program - Fagor CAT 40 NG Instrucciones De Uso

GB
The brewing unit is located behind
4.
the service door. Fig 29
Caution! Risk of burning through
hot brewing unit! If you have just
dispensed coffee, then the dispenser
could still be hot!
5/6 Remove the brewing unit by
inserting your index finger through
the ring of the coffee dispenser at the
front of the brewing unit and pull the
brewing unit straight forwards.
Prevent the brewing unit with the
other hand from falling. Fig 30, 31.
Cleaning the brewing unit /
inserting the brewing unit
The brewing unit is open and the
1.
ejection lever folds down. Turn the
brewing unit around. Both stainless
steel sieves are easily accessible now.
Fig.32
2. Clean the brewing unit under warm
running water, particularly the
stainless steel sieves must be well
rinsed and cleaned of coffee remains.
Dip the brewing unit in hot water to
release the dried coffee remains. Dry
the brewing unit. Fig.33
Inserting the brewing unit: Turn the
3.
brewing unit to the correct position
(the outlet tube faces forwards and
downwards), set the brewing unit in
the guide grooves and push the
brewing unit fully into the appliance.
Fig.34
4. Close the service door until it locks
audibly into position. Fig. 35
5. Reinsert the coffee grounds contai-
ner. Fig.36
The appliance can only be switched
on if the brewing unit is set in and the
service door is closed. After switching
on the brewing unit re-adjusts itself,
the normal heating process starts
again. When dispensing coffee for the
first time after cleaning, an increased
amount of water will access the
coffee grounds container.
44

15.6 Running the Cleaning Program

The cleaning programme allows complete
removal of coffee fat even at areas which are
not normally accessible. Start the cleaning
programme at the latest, when indicator k
"Start cleaning programme" flashes. The
cleaning process is carried out in 2 phases,
takes several minutes and should not be
interrupted.
In case of water insufficiency the appliance
will automatically turn off. Therefore it is
important that the water tank is filled
completely. Just clean the brewing unit after
the cleaning program has finished.
Please use only the cleaning tablets
recommended by the manufacturer. When
using other cleaning agents, the manufactu-
rer will not be liable for any damage.
Cleaning tablets are available from
specialized dealers or from the manufacturer.
Method phase 1: cleaning
Switch the appliance on. Use button f
"ON/OFF" for this purpose.
Directly after switching on, the appliance
adjusts itself.
The noises caused by this are normal.
Rotate the beans container to the position
"Powder mode". Wait till the mechanism is
set and all indications of the coffee grinding
quantity display go off. Fig. 38
Rinse the system twice, by pressing the
button d "Cup filling volume" until the
middle cup symbol "Coffee cup" has been
selected on the display.
Press the coffee requesting button b
When the rinsing process is finished, press
button b again.
Put a cleaning tablet in the coffee powder
duct. Fig.40
Press button k "Start cleaning program-
me" for 3 seconds. Fig.20
The Indicator k "Start cleaning program-
me" lights up after about 3 seconds.
and indicator h "Empty coffee grounds
container" starts flashing.
The appliance is activated and the resulting
noises are normal.
.