Reverberi M203 GL AUTOMATIC Instrucciones De Uso E Instalación página 17

Manuale del d'uso ed installazione – GL5Automatic
5.1 ELECTRICAL CONNECTION (Fig. 1)
The electrical power supply of the machine is to be connected following the instructions of the
manufacturer, who is therefore not liable for the same if it is connected incorrectly:
- Make sure that the connection point to the electrical mains guarantees the existence of all the protection
devices necessary and imposed by currently laws. The power supply socket must therefore be protected
with a differential circuit breaker of sufficient tripping capacity (the maximum input current is indicated
in the technical characteristics).
- Fit the machine plug (1) into a socket complete with earthing, making sure that the mains voltage
corresponds to that indicated on the nameplate on the back of the machine.
5.2 WATER CONNECTION (Fig. 1)
- Make sure the tap is closed (11).
- Fill the external tank with water (for irons, you are recommended to use demineralised water) or
connect to the main water supply.
5.3 WATER CONNECTION (Fig. 1)
- Connect the hose adapter (8) to the external tank or to the main water supply line using the pipe
supplied.
- Connect the discharge hose adapter (4) to the external tank supplied or to a drain.
5.4 STARTING
- Press switch 7 – boiler; when the water-steam pump starts it means that the water is being heated in
the boiler.
- The equipment reaches its ideal working conditions when gauge (5) settles at around 3 bar and LED
(14) switches off.
- Press button 6 – tool - to activate the utility (iron or steam gun).
- Whatever the type of work to be done, adjust the steam by turning the regulator (3) on the solenoid
valve (2).
- When you use the equipment, it is a good rule to check the water level in the external tank every 30-
40 minutes approximately.
del 17-10-2008 - C:\SETTORE STIRO\M203\MANUALE ISTRUZIONI\M203.doc
(Fig. A)
(Fig. B)
Pag. 17 di 56