Modes Of Operation; Continuous Mode; Control Panel Overview - Impecca IDM-95TEP Manual De Usuario

OPERATING INSTRUCTIONS (CONTINUED):

MODES OF OPERATION

There are three modes of operation: Comfort*, Standard and Continuous modes.
1. COMFORT MODE
Comfort mode is a setting whereby an ideal humidity setting (between 45-55% relative humidity) is auto-
matically chosen based on fluctuating environmental temperature. This is a great choice for a living space.
2. STANDARD MODE
In Standard mode, you can choose your desired humidity level from 35% to 85%. What level you choose
can depend on a number of factors including personal comfort, surrounding temperature and outside tem-
perature. Use the  and  buttons to select the desired level. After about four seconds, the display resume
showing the current humidity level. If at any time during operation you press the  or  key once, the display
will show the set level. It can be re-adjusted at any time.
NOTE: When operating in Comfort or Standard modes, the compressor and fan will cycle on and off as
needed to maintain the optimum or desired humidity level. At some point the unit may be completely
silent.

3. CONTINUOUS MODE

In continuous mode, the unit's compressor will run continuously until the unit is powered off or another
mode is selected. This will remove all the moisture from the air that it's capable of. This mode should be
used for the first three or four days after setting up your dehumidifier to get room and unit ready for proper
operation in Comfort mode or Standard mode at a set humidity level.

CONTROL PANEL OVERVIEW:

The following diagram and legend shows the functions of the front operating panel. Some functions are
only available on select models.
When you push the button to change operation modes, the unit will make a beep sound to indicate that it
is changing modes.
*Comfort mode not available on all models
LED lit: On LED lit:
Continuous Unit set to go on
mode on Off LED lit:
Unit set to go off
LED lit:
machine is in
Button: Button:
auto-defrost
Toggle mode Program timer
mode
Defrost Full
On
Off
TIMER
CONT.
PUMP COMFORT FILTER
LED lit: LED lit: LED lit: LED lit:
Pump mode Comfort Filter needs Turbo mode
on mode on replacement (high fan) on
Button:
Button: Button: Reset Button:
Toggle mode Toggle mode filter indicator Toggle mode
LED lit:
Tank is full
Humidity or
Time Delay
Display
Button:
Toggle Power
POWER
TURBO ION
LED lit:
Ion mode
on
Button:
Toggle mode
7
Fig. 4