Smalvic FI-74MT Manual De Instrucciones página 15

Fast heating function (for some functions only)
This function allows faster oven pre-heating.
After having selected the desired cooking function, press the
button. The elements most suitable for quickly reaching the set
temperature are activated and the
the display, which will disappear as soon as the temperature is
reached. The program will also emit a warning sign. At this point,
the system will state the previously set functions as active.
Fast heating cannot be activated with the GRILL function, when
the difference between temperature set and that to be reached
is lower than 50°C and when the temperature to reach is lower
than 100°C.
Temperatures display
The 5 bars near to the temperature set indicator show the
temperature level reached. The arrow facing upwards and
flashing signals that the oven is heating up. After cooking has
been interrupted, while the temperature inside the oven is
above 60 °C, a flashing downward arrow and hot will appear on
the display and will remain until the temperature drops below
60 °C.
Acoustic signal: the acoustic signal continues to ring at the end
of a program for approx. 7 minutes. To stop it, press
indifferently. It is possible to adjust the volume of the signal to
three levels: in the STOP position, operate on the
pressing it for approx. 5 seconds until the tone level currently
set appears. Operate on the
level.
Command tones
It is possible to modify the type of sound emitted when operating
on the commands.
In the STOP, position, slightly press the
seconds. Operate on the symbol again to select "bt" (beep
tone), "c" (click tone) or "nt" (no tone)
Energy saving
To limit the waste of electricity, the PS (Power Save) function
can be used. This function switches the oven off completely if, in
absence of cooking functions activated, there is no intervention
with any command. Press and hold the
seconds PS on will appear. The function is now active and the
oven will automatically turn off after approximately 1 minute.
Operate on the symbol to switch it back on..
Child safety
This function allows access to the functionality of the electronic
programmer keys to be blocked, both when the oven is running
and when the oven is off.
By operating on the symbol for 2 seconds, this function is
activated. This prevents children or other persons from pressing
the programmer keys involuntarily. Thus modifying the previous
program or from starting the oven that is off.
Every programmer signal that intervenes while the oven is on,
when the safety lock is activated, can be eliminated by pressing
any of the boxed keys. The safety lock will remain active
NOTE: The lock must be deactivated for access to a set
program.
INSTALLATION, USE AND MAINTENANCE INSTRUCTIONS
symbol can be seen on
or
symbol,
symbol again to set the desired
symbol for approx. 5
symbol for approx. 5
.
BUILT-IN ELECTRIC OVENS
Error signals
When situations occur that prevent normal operation of the
oven, the device informs this with a series of signals, such as:
Err1: communication error – Err2: PT1000 (probe) open circuit
– Err3: PT1000 (probe) closed circuit – Err4: temperature too
high on the display – Err5: temperature too high on the power
board – Err6: fault in the display – Err7: fault in the power board
– Err8: no heating is detected.
For the Err4 and Err5 errors, switch the oven off and allow it
to cool for a few hours and then try to use it again. If the error
persists, call the technical after-sales assistance. If any of the
other errors are present, the authorised after-sales assistance
must be informed.
EN
13