Smalvic FI-74MT Manual De Instrucciones página 29

Fig.1
Fig.2
Fig.3
Fig.4
Fig.4a
INSTALLATION, USE AND MAINTENANCE INSTRUCTIONS
To install the glass again (make sure it is placed in the correct
direction; the part with the graphics must be towards the inside),
position the upper clips A near to the moulded notches in the
glass (fig. 4/A). Insert the latter in the lower clips B, which must
be positioned correctly in place in the doorseats (fig. 2). Also
make sure you position the silicone rubber cylindrical gaskets
correctly (fig. 3). Now press the upper part of the glass and exert
a light pressure directly on the area with the upper clips A, until
a click is heard, which indicates that the glass has been blocked
correctly in position (fig. 4).
Before remounting the door, make sure the glass is firmly
secured into place.
Door model with profiles (removing the door of the
oven)
For this door model, together with the external glass, it is
possible also to extract the intermediate glass (third glass, if
present).
Remove the oven door, loosen the 4 clamping screws of the
steel plates C (fig. 5) that block the glass. Remove the windows
by extracting them from their seat.
Fig.5
Fig.6
Fig.7
Carry out the same steps in reverse order to remount the
glass surfaces. Take maximum care to ensure that they are in
the correct order and exact direction (the transparent glass, if
present, must be inside the other two) and the position of the
BUILT-IN ELECTRIC OVENS
EN
27