Maintenance Schedule; Mowing Blade Maintenance - Viking AMS 127 Manual De Instrucciones

Attaching the V-belt, attaching
the mowing deck at the rear
● Pull V-belt (1) forwards and fit
correctly onto the V-belt pulley (without
twisting).
● Lift up the mowing deck and hold. The
bores on the mounting must be aligned
with the bores on the mowing deck.
● Insert retaining pin (2) through the
bores, fasten with cotter pin (3).
● Repeat this procedure on the other
side.
Tensioning the V-belt
● Press V-belt tensioner lever (1)
forwards and hold in place.
Detach retainer (2).
● Tension the V-belt by relieving the load
on V-belt tensioner lever (1). Attach
retainer (2) to the V-belt tensioner lever.
7. Maintenance

7.1 Maintenance schedule

All the instructions in the maintenance
schedule for the ride-on mower must be
strictly observed. Additional or amended
maintenance operations when the mowing
deck AMS 127 is installed are noted
below.
Maintenance operations after each use:
– Remove grass residues and any other
dirt from the top of the mowing deck
AMS 127 and toothed belt (brush off or
blow off with compressed air).
20
Maintenance operations after every
25 operating hours:
23

– Mowing blade maintenance (

Check the blade fastenings and wear
limits, check the installation position of
the mowing blades.
Maintenance operations after every 100
operating hours:
– Replace mowing blades (
– Maintain the V-belt or toothed belt
(VIKING specialist dealer).
7.2 Cleaning
24
● Remove the mowing deck. (
● First, remove accumulated clipping
deposits in the mowing deck housing
using a stick.
● Clean the underside of the mowing
deck with water and a brush.
● When cleaning the upper side of the
mowing deck, ensure that the V-belt
and toothed belt do not get wet – never
spray water into the openings in the
covers.
● Clean the mowing blades with water
and a brush – under no circumstances
should you hit the mowing blades
(e.g. with a hammer) to loosen dirt.
7.3 Mowing blade maintenance
7.3):
Routing of the V-belt and toothed belt
and rotational direction of the mowing
blades:
7.3)
6.1)
Maintenance and checking of
toothed belts may only be carried
out by VIKING specialist dealers.
Checking the mowing blade wear
limits:
● Read and observe the section
"Checking the wear limits" in the
instruction manual for the ride-on
mower.
● Remove the mowing deck. (
● Turn over mowing deck (1) and set
down with the blades facing upwards on
wooden supports (2) approx. 20 cm
high and sufficiently long.
25
6.1)
0478 907 9922 A - EN