Bending The Head To Cut; Cutting Slots - Cutting At Two Passes - Sima Elite 123 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENG

9.2 BENDING THE HEAD TO CUT

Place the piece to cut on the bench.
Loosen the knob that blocks the rotation of the cutting unit.
Grasp the handle and raise the cutting unit.
Adjust the height of the suction tube and start cutting.

9.3 CUTTING SLOTS - CUTTING AT TWO PASSES

Place the piece to cut on the bench.
Loosen the knob that blocks the rotation of the cutting unit.
Set the cutting unit to the desired height and tighten the knob to lock the cutting unit.
Use the drive wheel or handle adapting them to the needs of the cut.
10
10
1 Pass cut
2 Pass cut
22mm
35mm
Rectangular
windows

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido