Controller Functions; Troubleshooting - Carrera RC Jeep Wrangler Rubicon Instrucciones De Montaje Y De Servicio

Controller functions

1
2
3
4

Troubleshooting

Problem Cause
Car does not move
Either the switch on the controller or the car is set to OFF.
There is no rechargeable battery in the car or the battery is too weak.
The overheat protection has caused the car's motor to cut out due to excess tem-
perature.
The battery or rechargeable battery in the transmitter or model is too weak.
Different channel set up for car and controls.
Car cannot be
Transmitter antenna is defective.
controlled
Another RC model is using the same frequency.
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
Full Function
You can steer the car in any direction
using the joysticks:
Joystick on left:
forwards/backwards
Joystick on right:
left/right
The joysticks are removable.
Alternatively, the vehicle can be
controlled with a rocker.
The joysticks can be stored in the spe-
cial compartment at the back of the
controller.
Attach the lanyard to the eyelet on the
controller and let the controller hang
from your neck.
Operating the rope winch
1
2
3
High Speed Turbo Button
1
Solution
Switch on.
Insert charged battery.
Switch off the receiver.
Leave the RC car to cool down for approx. 30 minutes.
Insert new battery or recharged battery.
Switch to same channel.
Extend the antenna fully.
Change the frequency.
11
Release the winch hook from the
bumper and press the release button
to the right of the winch.
While keeping the release button
pressed, unwind the winch until the
rope is of the desired length and hook
to an object or position.
The tensile force of the winch is up to
2.5 kg.
Press the button on the right-hand side
of the controller to activate the winch's
roll-up mechanism.
Press the button on the left-hand side
of the controller to actuate the High
Speed Turbo function.