Carrera RC Jeep Wrangler Rubicon Instrucciones De Montaje Y De Servicio página 10

Charging the rechargeable battery Aufladen des Akkus
1
2
RED = Charging GREEN = Ready
Installing the rechargeable battery Einsetzen des Akkus
1
2
Inserting the 9 V block battery Einsetzen des 9V-Blocks
1
2
First connect the Carrera RC rechargeable
battery to the battery charger supplied. The
connection terminals between the battery
and the charger are designed to prevent
connection with the wrong polarity. Connect
the charger to a power source.
When the battery is properly connected and
charging normally, the red LED is constantly
lit. Once the battery is fully charged, the red
LED switches to green. The battery can now
be disconnected and installed in the Carrera
RC car.
The car is now ready for use.
Using a screwdriver, remove the cover of the
battery compartment in the Carrera RC car.
Connect the end of the cable from the Car-
rera RC vehicle with the charged battery. Put
the battery in place.
Replace the compartment cover using
a screwdriver.
Unscrew the cover of the battery compart-
ment in the controller and insert the 9 V
block battery.
When inserting the 9 V block battery, ensure
that the polarity is correct. Replace the cover
using a screwdriver.
Now you can drive the car
1
2
3
4
5
Let's practise!
1
• Avoid constant motor operation.
• To switch off after use, follow the steps in the reverse order.
• After use, remove or disconnect the battery.
• Clean the Carrera RC car after use.
10
Make sure that nobody in your vicinity
is using the same frequency.
To avoid this and to ensure that your
vehicle will receive the signal from your
controller, make sure that both your car
and the controller are set to the same
frequency (A/B/C).
The use of different channels allows
three vehicles to be operated at the
same time.
Pull out the antenna of the controller to
its full extent.
Switch on the Carrera RC car using the
ON/OFF switch. Your Carrera RC car
has two speeds.
The ON/OFF switch is also used to
select the training or indoor mode.
Adjusting the steering
If the Carrera RC vehicle is found to pull
towards the left or right while moving,
use the adjuster control shown in the
illustration to adjust the car's track pre-
cision.
Now it's time to practise! Set up a Car-
rera RC vehicle racing track in a large
empty area, using cornerposts, empty
cans, or similar objects. The basic tech-
nique to adopt when operating a Car-
rera RC is to drive fast on the straight
sections and to slow down in the
curves.