Taurus IDEAL LITHIUM Manual De Instrucciones página 14

ASSEMBLING THE WALL BRACKET:
- The appliance comes with a wall bracket (C),
so it can be hung on the wall
- The product can be charged without using the
wall bracket To do this, unscrew the rear cover
on the wall bracket (D) and extract the charger
cable, which can be connected directly into the
vacuum cleaner body.
- Fix the wall support as you think appropriate,
using wall plugs, screws, adhesive...
- Make sure that the bracket is firmly fixed; it
should be able to support twice the weight of
the appliance.
- Fit the appliance into the wall support.
CHARGING THE BATTERY
- Caution: The new battery does not come
completely charged and must be charged up
to the maximum before using the appliance for
the first time.
- Charge the battery at room temperature be-
tween 4 and 40ºC.
- Plug the charger(R) into the mains.
- - Approximately 3-4 hours are needed for a
complete charge of the battery. Never attempt
to over charge the battery (although it is recom-
mended that the first charge of the battery be
of 5 hours in duration).
- Connect the charger to the jack using the
socket on the appliance. The socket is located
at the lower/back part of the appliance.
- While the battery is charging, the pilot light will
come on indicating that the charger is charging
the battery.
- After the specified time, remove the battery
from the charger.
- When the battery is charged disconnect the
charger from the mains supply.
- Note: Do not use the appliance while it is con-
nected to the charger.
- Note: For a long battery life, it is advisable to
charge the battery, only, when it has run out
completely.
INSTRUCTIONS FOR USE
BEFORE USE:
- Before using this product for the first time, it is
important to make a full charge of batteries.
- Prepare the appliance according to the function
you wish to use.
VACUUMING FUNCTION:
- Attach the vacuum's air intake tube and the
brush base to the end of the extension tube(E).
- To uncouple the extension tube from the vacu-
um, press the accessory release button (L) and
pulll outward. (Fig. 3).
USE:
- Turn the appliance on using the on/off button.
(N)
- The "on" light on the brush base and the bat-
tery indicator will both light.
- Select the desired speed (1 / 2) by pressing the
on/off button once or twice. Pressing the button
3 times switches the appliance off.
FITTING AN ACCESSORY TO THE HAND-
HELD VACUUM CLEANER OR EXTENSION
TUBE:
- The hand-held vacuum cleaner and the exten-
sion tube are designed in such a way to allow
the following accessories to be fitted: (use
the combination that best meets your require-
ments). (Fig. 4).
- 2-in-1 Accessory:
-A-1 Upholstery brush
-A-2 Crevice lance
- Long lance
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off, using the on/off switch.
- Remove the batteries from the appliance if you
are not going to use it for some time.
- Clean the appliance
CLEANING
- Disconnect the charger from the mains and let
it cool before undertaking any cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
to clean the appliance.
- Do not submerge the appliance in water or any
other liquid, or place it under a running tap.
EMPTYING THE DUST BOX:
- Empty the vacuum deposit when dust is visible
though the transparent walls, when it is full, or
when the vacuum cleaner does not work to its
full potential.