Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
6.
Installation
6.1 Connecting the Base of the Camera
If it is not yet done, screw the base [11] on the bottom of the camera (see
illustration A). The base allows you to fix the camera:
•
on the handlebar of your bicycle using the handlebar bracket
•
on your helmet using the Velcro or rubber strap using the helmet
bracket
•
or directly onto a tripod, using the screw hole in the base.
6.2 Mounting the Camera on a Handlebar
1.
Slide the handlebar bracket [13] over the handlebar (see
illustration B).
Tip: If necessary, insert one or more rubber pads between bracket and
handlebar to ensure a tight grip.
2.
Fix the bracket with the screw and bolt [14] (see illustration C).
3.
Slide the camera base in the handlebar bracket until it clicks into place
(see illustration D).
4.
Adjust the camera position: loosen the ring [5], adjust, then tighten
again to keep the camera firmly in place.
5.
To adjust the bracket position: loosen the bolt [14], reposition the
bracket on the handlebar, then tighten the bolt again (see
illustration E).
6.
To take the camera off the bracket again, squeeze the camera base
handles [12] together and slide the camera off the bracket.
6.3 Mounting the Camera on a Helmet Using the Rubber Strap
1.
Thread the rubber strap [17] through the helmet bracket [15] (see
illustration F).
2.
Fit the strap over the helmet with the bracket in the desired position
(see illustration G).
3.
Make sure the strap fits tightly around the helmet.
4.
Slide the camera into the bracket (see illustration H).
5.
Adjust the camera position: loosen the ring [5], adjust, then tighten
again to keep the camera firmly in place.
6.4 Mounting the Camera on a Helmet Using the Hook-and-Loop
Strap
1.
Thread the hook-and-loop strap [16] through the helmet bracket [15]
(see illustration F).
2.
Place the bracket on the helmet in the desired position and thread the
strap through the helmet vents (see illustration I).
3.
Tighten the strap and fix the ends together to keep the bracket in place.
4.
Slide the camera into the bracket (see illustration J).
V. 02 – 02/10/2012
CAMCOLVC18
6
©Velleman nv
Publicidad
Tabla de contenido
